providing solutions for Electrical Submersible Pump completions
Copyright Petrosolus Limited 2020 ,Company Number GB 12259114 ,United Kingdom – all rights reserved | Privacy and Cookies | Terms of Use
ISOL-8 – Pod/Canister system
ISOL-8 Plus – dual Pod/Canister system
Bespoke Y-tools – Single and dual ESP bypass
Motor Shroud
MLE Clamp
Solus Diverter Valve
Non-Return Valve (NRV)
ESP Hydra-Loc
Anode Centraliser
ESP Centraliser
Gas Vent Valve
Chemical Injection Sub
Discharge Pressure Sub
Tubing Centraliser
Orientation Sub
Adjustable Union
Junk Basket
Standard Nipple
Drain Valves
ESP Choke
BOP Can
Y-tool – Connects ESP and tangential Bypass tubing to Production tubing
Blanking Plug – Seals junction in Y-tool to prevent recirculation
Neck Clamp – Attaches Bypass tubing to ESP unit
Motor Base Unit – Lowermost attachment point for Bypass tubing to ESP unit
Bypass Tubing – Tubing that runs parallel to ESP
Re-Entry Guide – Eases entry of wireline tools int Bypass tubing
Y-tool Top Nipple – Allows Standing Valve or Isolator tool to be set in Y-tool
Non-Return Valve – One way check valve prevents fluid return to ESP
Adjustable Support Block – Used to hang heavy loads below ESP when using Y-tool
Isolator Tool – Isolates y-junction of Y-tool
Standing Valve – Seals above Y-tool y-junction to pressure test
Wireline Logging Plug – Allows production logging through Y-tool using standard wireline
CT Logging Plug – Allows production logging through Y-tool using standard CoiledTubing
Stove Pipe Installation Table – used during installation of Y-tool Bypass system
Bypass Tubing Set Clamp – used during installation of Y-tool Bypass system
Hanger ISOL-8 – Top seal assembly for Pod or Canister
Adapter – Top section for Casing joint for Pod or Canister
Lower Crossover – Bottom component for Pod or Canister vessel
Offset Orientation Sub – Aligns ESP to Hanger
Offset Stroke Adjuster – Aligns ESP to Hanger and provides length adjustment
Solus Diverter Valve – Automatically opens or closes production tubing to annulus on ESP operation
Top Hanger ISOL-8 PLUS – Top seal assembly for Pod or Canister
Mid-Pac Hanger ISOL-8 PLUS – Mid seal assembly for Pod or Canister
Pod Canister Casing – API Casing forming Pod or Canister vessel
Pod Canister Tester Valve – Allow in-line testing of Pod or Canister vessel
Elevator Lift Sub – Installation tool for Pod or Canister
Stabbing Guide – Installation tool for Pod or Canister
Motor Shroud – provides motor cooling during ESP operation
MLE Clamp – attaches MLE and Sensor line to ESP unit
ESP Hydra-Loc – Hydraulically locks ESP unit to casing bore
Anode Centraliser – provides cathode protection for ESP
ESP Centraliser – Centralises ESP unit to casing bore
Gas Vent Valve – Vents gas from inside a Pod or Canister
Chemical Injection Sub – Allows injection of chemicals below ESP
Orientation Sub – Provides alignment of eccentric tubing assemblies
Adjustable Union – Provides length adjustment for tubing assemblies
Junk Basket – Protects ESP or downhole assemblies from junk in the well
Standard Nipple – Allows setting of various wireline plugs
Drain Valve – Allows drining of production tubing if ESP blocks
BOP Can – Allows wellhead testing when using ESP for DST